Page 3 of 3
Re: Lead & Tags
Posted: Wed Feb 01, 2017 8:22 am
by Jim Frame
One swipe with a square-point shovel and there'll be no need to wait for corrosion to finish the job.
Re: Lead & Tags
Posted: Wed Feb 01, 2017 8:40 am
by Peter Ehlert
Jim Frame wrote:One swipe with a square-point shovel and there'll be no need to wait for corrosion to finish the job.
very true... far from durable regardless the fasteners
Re: Lead & Tags
Posted: Wed Feb 01, 2017 8:43 am
by Edward M Reading
Boom. Done.

Re: Lead & Tags
Posted: Wed Feb 01, 2017 12:39 pm
by DWoolley
Here's where the rubber meets the road. Figuratively, we can agree a Twinkie is likely to have a longer shelf life than a cup tack. Is setting a cup tack as a monument negligence? Negligence is defined as a failure to meet the standard of care.
Anyone willing to lay odds or take bets on what BPELSG staff would do with a complaint for the same?
DWoolley
Re: Lead & Tags
Posted: Wed Feb 01, 2017 12:49 pm
by Mr. Smith
But the lead in the hole continueth forever
Re: Lead & Tags
Posted: Wed Feb 01, 2017 4:30 pm
by btaylor
Edward M Reading wrote:Boom. Done.

I use these as well. Out here I do not worry about countersinking but you can buy their bit and countersink those in areas where people are concerned about them being bladed out
Re: Lead & Tags
Posted: Wed Feb 01, 2017 5:42 pm
by Anthony Maffia
Or concerned about it being a tripping hazard in a sidewalk.
BTW, a deceased surveyor in Oakland, a friend of mine, used to set his random traverse points at very conspicuous locations in sidewalks near intersections. He'd countersink a nail & washer down 3/8" or so from the concrete surface. What was COOL was that the washers had his name & telephone number, then he filled the hole with epoxy so they were like little business cards. Anyone looking for a surveyor would see them and call.
Re: Lead & Tags
Posted: Fri Feb 03, 2017 10:38 am
by Tom Herrin
Regarding durable nails, we have been using bronze ring shank nails, sourced from boat building suppliers, for most all cases where tags are being set. Seem to be holding up well over time. Took a while to find these after one of our local surveying suppliers stopped carrying a similar item.
https://www.jamestowndistributors.com/u ... Ring+Nails
Re: Lead & Tags
Posted: Fri Feb 03, 2017 11:27 am
by Peter Ehlert
Tom Herrin wrote:Regarding durable nails, we have been using bronze ring shank nails, sourced from boat building suppliers, for most all cases where tags are being set. Seem to be holding up well over time. Took a while to find these after one of our local surveying suppliers stopped carrying a similar item.
https://www.jamestowndistributors.com/u ... Ring+Nails
great idea!
here is a West Coast supplier, with many retail stores (shop local) WestMarine
https://www.westmarine.com/buy/fasco-fa ... 90_002_016