PG&E Easement Requirements - Tool for Projected Township and Range?

[JoshPLS]

Hi All,

Any of you have recommendations for a speedy, but accurate way to determine projected township/range in Rancho areas?

I seem to remember a slick KMZ or KML that overlayed in Googleearth Pro awhile back, but I cannot seem to locate it.

What do you guys/gals use?

[David Kendall]

What do you guys/gals use?

For PGE easements you should ask them to determine the projection. I have spent a great deal of time on this in the past and made some determinations only to have them come back and tell me they are in a different projected quarter section.

It turns out they have their own ancient overlays that they have been using for decades and that is how they want it arranged. They are loosely based on the USGS topo quads but you are better off just letting them tell you how to designate. If the site turns out to be close to a line or if you strongly disagree with them and are not comfortable certifying to the "wrong" projected quadrant then they are usually pretty flexible about letting you designate two different quarters.

Short answer is just take a guess and let them correct you on their plan check is the easiest way. I use EarthPoint for my guessing:

https://www.earthpoint.us/TownshipsCalifornia.aspx

https://www.earthpoint.us/TownshipsCali ... atLon.aspx

[mpallamary]

Look for some old Rancho maps at the BLM. They often show them depending on when the rancho was confirmed.

[mpallamary]

https://www.blm.gov/basic/contact-us-ca ... ate-office

[JoshPLS]

What do you guys/gals use?

For PGE easements you should ask them to determine the projection. I have spent a great deal of time on this in the past and made some determinations only to have them come back and tell me they are in a different projected quarter section.

It turns out they have their own ancient overlays that they have been using for decades and that is how they want it arranged. They are loosely based on the USGS topo quads but you are better off just letting them tell you how to designate. If the site turns out to be close to a line or if you strongly disagree with them and are not comfortable certifying to the "wrong" projected quadrant then they are usually pretty flexible about letting you designate two different quarters.

Short answer is just take a guess and let them correct you on their plan check is the easiest way. I use EarthPoint for my guessing:

https://www.earthpoint.us/TownshipsCalifornia.aspx

https://www.earthpoint.us/TownshipsCali ... atLon.aspx

Thanks David this is likely the same KML/KMZ I was using before that I somehow lost.

[RAM]

here, all projected sections are shown on our APN maps. Has nothing to do with PGE.

[Peter Ehlert]

Sonoma County, Healdsburg area

Township/Sections laid out and platted by GLO...but later, same land accepted as a Rancho.

I forget the particulars, but i did many aliquot part surveys of "Sxx, Txx, Rxx, xxxRancho".
Ask the locals... Bob Curtis if possible