NGS published elevations

Post Reply
MikeTurnrose
Posts: 218
Joined: Thu Apr 01, 2010 9:41 am

NGS published elevations

Post by MikeTurnrose »

Recently I measured to a BM that was an HP GN station, however the published elevation was only to nearest foot. Is there a way to obtain a more accurate elevation. It was a Cal Trans disk.
User avatar
pls7809
Posts: 1035
Joined: Tue Apr 13, 2004 3:48 pm
Location: Chino, CA

Post by pls7809 »

You would probably need to seek that info at the Caltrans District Survey office for the district you are working in.
Ryan Versteeg, PLS, CFedS
User avatar
Jim Frame
Posts: 1599
Joined: Thu Oct 17, 2002 8:52 pm
Location: Davis, CA
Contact:

Post by Jim Frame »

Without a specific station ID it's hard to tell if there's better elevation data out there. In 2004 Caltrans observed a bunch (about 700) stations to height mod specs, and ran a bunch of geodetic levels to supplement the network, but hasn't been able to come up with the money to have an orthometric height adjustment performed. Some of those stations were subsequently included in the 2008 DWR project -- which covers most of the Sacramento Valley -- but those have been published, so I'm assuming that your station isn't one of them.

.
Jim Frame
Frame Surveying & Mapping
609 A Street
Davis, CA 95616
framesurveying.com
MikeTurnrose
Posts: 218
Joined: Thu Apr 01, 2010 9:41 am

benchmark

Post by MikeTurnrose »

Ryan,

I put in a call into the district office today and left a message. Hopefully, I'll get some more info. Thanks.

Jim,

I think the point I found has a station ID. I'll have to check when I go into the office. Thanks.
Post Reply